Magnizon-Pure Sine Wave Inverter 24vdc 230v, 50/60hz, 4000w – Aps-4024sw-Lcd
Provide Pure Sine Wave power for all your alternative energy needs with the Magnizon APS-4024SW-LCD. This inverter/charger supplies 4000 watts of continuous 230V /50Hz AC power.
Reliable large pure copper-based transformer design and frequency-controlled power, very much compatible with all varieties of loads: resistive loads such as refrigerators, motors, pumps, compressors, and laser printers as well as electronic loads like TVs, Computers, power tools, and battery chargers.
Smart microcontroller-based 3-stage charging system properly charges and maintains battery bank. The charge rate is selectable so you can use a variety of battery sizes and types to fit your backup time requirements.
Key Features
- 48V DC or 230V AC input; 230V, 50 Hz output (hardwired)
- 4000 watts continuous output, 8000 watts peak output
- Microprocessor-controlled Smart-UPS & Solar operational mode
- 4-Step Progressive Charging & 7-Battery Type Selector
- Fully compatible with Solar/Wind solutions for Hybrid configuration
- Pure sine wave output with a large LCD display
- High Efficiency Using Line-Interactive Circuit Topology(Full Bridge Topology)
- Quiet, high-efficiency operation, high surge capacity, and low idle current
- CE Safety
Applications
- Well designed for hybrid applications where solar/wind energy systems are connected along with grid or generator sets without using any relay and control mechanism.
- Versatile inverter/charger with pure sine wave system with seamless transfer switching serves as an automotive inverter for RVs, trucks, and standalone alternative power source with high-end backup times with various battery technologies(VRLA, GEL, Deep cycle, Ni-Cd, and many more)
- Off-grid and On-grid applications.
- Telecom and ATM applications.
- Remote closets and small computer room applications.
- Petrochemical application
- Critical applications where higher reliability is needed
- Medical & lifesaving equipment
- SMB requirements
Product Specifications
INPUT AC
| Input Wave Form |
Sine wave (Utility or Generator) |
| Nominal Voltage |
230V AC |
| Low Voltage Trip |
154V +/- 4% |
| Low Voltage Re-engage |
164V +/- 4% |
| High Voltage Trip |
253V +/- 4% |
| High Voltage Re-engage |
243V +/- 4% |
| Max Input AC Voltage |
270V |
| Nominal Input Frequency |
50Hz or 60Hz (Auto detect) |
| Low-frequency trip |
47Hz for 50Hz, 57Hz for 60Hz |
| High-frequency trip |
55Hz for 50Hz, 65Hz for 60Hz |
| Output Waveform(bypass mode) |
Same as Input |
| Overload protection |
Circuit breaker |
| Short circuit protection |
Circuit breaker |
| Efficiency online transfer mode |
0.95 |
| Line transfer time |
10 mSec Typical |
| Bypass without Battery connected |
Yes |
| Max bypass current |
40Amp |
INVERTER SPECIFICATION/ OUTPUT
| Output Waveform |
Pure Sine wave |
| Output continuous power in Watts |
4000 |
| Output continuous power in VA |
4000 |
| Power Factor |
1 |
| Nominal Output Voltage RMS |
230V AC (L-N) |
| Output Voltage regulation |
+/-10% rms |
| Output frequency |
50Hz +/-0.3Hz or 60Hz+/-0.3Hz |
| Nominal Efficiency |
>88% |
| Surge rating |
9000 |
| Short circuit protection |
Yes, fault after 10sec |
INVERTER SPECIFICATION/ INPUT
| Nominal Input Voltage DC |
24V |
| Minimum start voltage DC |
20V |
| Low battery Alarm |
21V |
| Low battery trip |
20V |
| High Voltage Alarm |
32V |
| Power Saver |
Below 25Watts when enabled |
| Power Saver |
The same switched On/Off remote |
| Input connection type |
Terminal block with secure enclosure |
CHARGER MODE SPECIFICATION
| AC input Voltage Range |
164-253V AC |
| Output Voltage (DC) |
Depends on battery type |
| Battery Charge Current |
65Amp |
| Battery initial Voltage for start-up |
0-31.4V DC |
| Overcharge protection shutdown |
31.4V DC |
BATTERY TYPE
| Gel USA (Boost Voltage) |
14.00 |
| AGM.1 (Boost Voltage) |
14.10 |
| AGM.2 (Boost Voltage) |
14.60 |
| Sealed Lead acid (Boost Voltage) |
14.40 |
| Gel Euro (Boost Voltage) |
14.40 |
| Open Lead acid (Boost Voltage) |
14.80 |
| Calcium (Boost Voltage) |
15.10 |
| Gel USA (Float Voltage) |
13.70 |
| AGM.1 (Float Voltage) |
13.40 |
| AGM.2 (Float Voltage) |
13.70 |
| Sealed Lead acid (Float Voltage) |
13.60 |
| Gel Euro (Float Voltage) |
13.80 |
| Open Lead acid (Float Voltage) |
13.30 |
| Calcium (Float Voltage) |
13.60 |
| De-sulphation |
15.5 for 4hrs |
SYSTEM SPECS
| Remote control/RS232/USB |
Yes. Optional |
| Size (in mm) |
598x218x119 |
| Weight |
35kgs |
| Warranty |
2 Year limited warranty Extendable up to 4 years |
| Safety |
EMC/CE/ROHS/ISO9001/ISO14001 |
CERTIFICATION/CONFORMITY
| Disturbance at Mains Terminals |
EN61000-6-3:2007+ A1: 2011+ AC:2012 |
| Radiated Disturbance |
EN61000-6-3:2007+ A1: 2011+ AC:2012 |
| Harmonic Current Emission |
EN61000-3-12: 2011 |
| Voltage fluctuations & flickering |
EN61000-3-11: 2000 |
| Electrostatic Discharge (ESD) |
IEC 6100-4-2:2008 |
| Radio-frequency & continuous radiated disturbances |
IEC 6100-4-3:2006 + A1:2007 + A2:2010 |
| EFT/B Immunity |
IEC 6100-4-4:2012 |
| Surge immunity |
IEC 6100-4-5:2014 |
| Conducted RF immunity |
IEC 6100-4-6:2013 |
| Power frequency magnetic field |
IEC 6100-4-8:2009 |
| Voltage DIP |
>95% reduction, IEC 6100-4-11:2004 |
| Voltage DIP |
>30% reduction, IEC 6100-4-11:2004 |
| Voltage Interruption |
IEC 6100-4-11:2004 |
For more information check out the Datasheet Provided
Reviews
There are no reviews yet.